FluidLab

Rising bubble, two phases on a grid

A gas bubble starts at rest inside a heavier liquid and rises under buoyancy. There is no interface to draw: the boundary between the phases emerges from the interaction between neighbouring densities.

200 × 240 · periodic

Bubble size and rise speed are measured from the density field every 0.2 s; the aspect ratio is width ÷ height, so < 1 means the bubble has stretched into a vertical ellipse.

Bubble diameter
—
Aspect b/h
—
Rise speed
—
Area
—
Steps
—
Stability
—

How a bubble can exist here

A single-phase solver has one density everywhere. To get two phases you add a force between neighbouring cells that depends on a pseudopotential, ψ(ρ). With the right weights and a negative interaction strength, uniform fluid becomes unstable and splits into a dense phase and a light one, separated by a diffuse interface a few cells thick.

That is the Shan–Chen model. It costs almost nothing: one extra loop to compute ψ, one to apply the interaction force, and the same collision and streaming as the single-phase solver. It also has the model's characteristic weakness — the interface is not thermodynamically consistent, so it produces the parasitic currents you can see as shimmer.

What to watch

early

It starts to move

Buoyancy acts on the density difference, not on a prescribed velocity. The rise speed readout is the drift of the bubble centroid, so it starts near zero and settles into a terminal value.

middle

It flattens

The pressure field squeezes the rising bubble into a horizontal ellipse: the aspect ratio falls below 1. Raise gravity and the deformation gets stronger.

later

It leaves a wake

Switch to vorticity: a pair of counter-rotating vortices trails under the bubble. In a taller domain the column would start to wobble — that is the path to the zig-zag regime.

Honest limits

The domain is periodic and only 200×240 cells, so the bubble is never far from its own wake — it rises back into it. The density ratio is about 26:1 rather than the ~800:1 of water and air, which flattens the dynamics. And the interface is several cells wide by construction, so surface tension is not a tunable parameter here.

What the page is good for is the shape of the phenomenon: why a bubble deforms, how the wake forms, and what happens when you make it bigger, heavier or more viscous. That intuition is exactly what an interface-resolving solver would give you at a hundred times the cost.

FAQ

Why does the bubble deform instead of staying round?

Buoyancy pushes harder on the underside than on the top, so the pressure field squeezes the bubble into a flattened ellipse — the aspect ratio readout drops below 1 as it accelerates. At higher gravity it becomes an indented “skirt” shape, the classic regime map for rising bubbles.

What are those wiggles at the interface?

Spurious currents. In pseudopotential models the interface carries a small parasitic velocity even at rest, because the discrete force is not exactly balanced by the pressure gradient. Raising viscosity damps them; they are the main visual artefact of this method.

Why is the density ratio only about 26:1?

Shan–Chen models lose stability as the density ratio grows, and 26:1 is roughly what this grid and relaxation time tolerate while staying clean. Water and air are about 800:1 — for that you need a different method (colour-gradient or free-energy models).

Is this the same solver as the cylinder page?

No. The cylinder page is single-phase: one density, no interface. Here an interaction force between neighbouring densities creates phase separation, which is why a bubble can exist at all.